Copper Prep Sinks and Copper Bar Sinks made in the USA
Our most popular bar and prep sink size is generally built quickly. This seems to be the perfect size for a bar or smaller secondary sink. Don't forget to order a drain or flange with your sink. This sink has a standard kitchen size drain. If you would like a REAL Prep Sink, scroll down and order a custom Prep or Bar sink.
This sink is 18" square, 7" deep, with a right rear drain. Inside measurement is 16" by 16"
Made by Rachiele in the USA of 14 gauge cold rolled USA copper. We decided to stack and cut quite a few of these at once, lowering our cost below normal wholesale to produce them. No customization at this price. These sinks can generally ship quite quickly.
Custom Prep or Bar Sinks. Folks, a PREP sink should allow you to prepare something, not simply run water. My workstation Prep and Bar Sinks allow for a tremendous amount of prep work in a small space. Remember, Rachiele® invented the workstation sink! Seriously... are you going to cut a lime or lemon on a board that you have to hunt for, then clean, dry and put away? Why not have one alread on the sink? We make them small so they to just the right job. The sinks and accessories are customized to how YOU will use YOUR sink! Call and chat with me a bit. 407-880-6903
See the Entertainer bar sink by clicking above to our trough sink page.
Butcher grade board with two stainless bowls recessed into the board.
Photos of several bar or prep sinks. The workstation sinks shown here are our Signature Series model.
This sink with the black accessory and the hammered sink are both 18" square sinks with rear corner drains.
Please do not order these online. Call me and we will work out the perfect sink over the phone. Pricing is for you to have a general investment estimate. 407-880-6903
|Custom Copper Undermount Prep or Bar Sinks|
|Starting at: $1,620.00|
These are our options for round sinks. This sink is built in three or four pieces. The top flange is one piece, the side is another, and the bottom is the third piece. If the sink is a top mount sink, a fourth small piece is welded by hand all around the flange so the sink sits about 1/4" proud of the countertop. These round sinks are nothing like the ones you likely see elsewhere. Our round sinks require a tremendous amount of welding, forming and finishing - to say nothing of the precision required.
|Custom Round Copper Prep,|
Lavatory or Bar sink
|Starting at: $2,486.00|