Rachiele^® Kitchen Sink Specifications and Cabinetry Planning Guides

All designs on this page are copywrited designs and some are patented designs specifically designed by Dino Rachiele and should not be coppied without permission.

IMPORTANT: Keep in mind, all of our sinks are custom made to suit the owner(s), therefore many changes from these specifications will likely be made. The specifications below are accurate enough for 90% of the planning needed for cabinet installation.

PLEASE NOTE: OUR SINKS SHOULD NEVER BE INSTALLED SITTING ON A SHELF OR SUPPORTED BY A SHELF BELOW THE SINK. THE SINK SHOULD ONLY BE SUPPORTED BY THE FLANGES AND THERE SHOULD BE ROOM FOR AIR MOVEMENT BELOW THE SINK.

Our most common sizes of kitchen, bar and prep sinks are listed below. Keep in mind, we are a custom manufacturer. All specifications on this page are for right rear drains and dimensions will likely vary a bit based on your personal design. If you are left handed, we will design you a custom left drain sink. If your sink is not listed on this page, we will be drawing up (and emailing) a custom set of specifications after you place your order. NOTE: Drawings are not to scale and many refer to copper - however specifications are identical in stainless and brass sinks. You will receive accurate specifications when you order. Keep in mind, the bottoms of our sinks are sloped to the drain. Portions of the sink will be lower than the specified dimensions.

NOTICE: Many of our specifications have changed due to improvements in design. The specifications on this page may not be current, however they are quite sufficient for general cabinet planning. NexGen and Signature Series overall dimensions are the same. You will receive custom drawings when you order your sink. Our sinks are not limited to the sizes you see below. We have built sinks longer than 96" and in shapes that are quite unusual. We are up to any challenge. In fact, we are being commissioned to build a 13 foot long single bowl sink for a residence!

Farm Cabinet Guide

Farmhouse Sink Specifications

Under Mount Cabinet Guide

Under Mount Sink Specifications

Farmhouse Workstation Sinks

Under Mount Workstation Sinks

Prep and Bar Sink Specifications

18" Under Mount Bar/Prep Sink
18" Apron Bar/Prep Sink
24" Under Mount Bar/Prep Sink
18" Signature Series Workstation Prep Sink
24" Signature Series Workstation Prep Sink
Evolution - The Ultimate Workstation Sink Specifications not available online

Please email a request.

Corner Sink Specifications

Single Bowl Corner Sink - Under Mount

Top Mount Specifications (general)

Retrofit Apron (Farmhouse) Sink Specifications

Critical information! You must tell your counter top fabricator that the cut out on our sinks should be FLUSH with the inside of the bowl. Your Signature Series or NexGen™ accessories will NOT fit if there is any overhang of the counter top. This is a standard practice, however, some fabricators like to have a small overhang (basically so they don't have to be as accurate when cutting the granite). By the way, a reveal is also an improper installation! Never use silicone when installing a copper sink. Also note: These specific sink designs are Trademarked and copyrighted by Rachiele, LLC.